如图所示,在VMWare虚拟机安装Kali之后出现不能自动获取到ip的情况.
首先是ping了一下出现如下的错误:
root@kali:~# ping 192.168.1.1 connect: Network is unreachable试了一下重新启动网络服务:
root@kali:~# service networking restart [....] Running /etc/init.d/networking restart is deprecated because it [warnot re-enable some interfaces ... (warning). [....] Reconfiguring network interfaces...Internet Systems Consortium DHCP Client 4.2.2 Copyright 2004-2011 Internet Systems Consortium. All rights reserved. For info, please visit https://www.isc.org/software/dhcp/ Listening on LPF/eth0/00:50:56:27:52:c8 Sending on LPF/eth0/00:50:56:27:52:c8 Sending on Socket/fallback DHCPRELEASE on eth0 to 192.168.1.1 port 67 send_packet: Network is unreachable send_packet: please consult README file regarding broadcast address. Reloading /etc/samba/smb.conf: smbd only. done.然后是检查DNS:
root@kali:~# cat /etc/resolv.conf nameserver 192.168.1.1192.168.1.1在里面, DNS设置没有问题
再检查网卡:
root@kali:~# cat /etc/network/interfaces # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface allow-hotplug eth0 iface eth0 inet dhcp网卡自动激活, 并配置dhcp获取IP方式,这没有错呀.
最后就只能检查VMWare 桥接设置了:
由于我装有Virual Box & VMWare Workstation, 所以有多个虚拟网卡, 桥接为自动模式, 心想是不是自动桥接到不能连外网的Virtual Box的虚拟网卡了? -_- | (貌似是的!)
果断选成实际外网网卡, 重启Kali Linux networking服务, 问题解决.
希望可以帮到有同样困扰的朋友.欢迎转载,请注明出处.Mrxn's Blog https://mrxn.net 谢谢
